Name: BetaFPV BEC Board for Naked Camera Gopro Hero 6/7 BT-HERO6/7
SKU: BT-HERO6/7
Price: 39.00 MYR
Availability: OutOfStock

BetaFPV BEC Board for Naked Camera Gopro Hero 6/7 BT-HERO6/7

Bullet point

BEC Board is specially designed for Naked GoPro HERO6/7 which weighs about 1.5g, makes your naked GoPro lighter and easy to install on your drone.

The BEC output voltage is 5V@2A, avoid the accident of power of which is caused by the insufficient power supply for the FC board. Also, stock buttons and LEDs are integrated.

Integrated GoPro stock buttons, Power/Mode Button and Record Button.

Integrated GoPro stock LED to know the status of the camera.

The pad is available for pilots to control the GoPro recording via the radio transmitter.

With the pluggable connector, which is easier to connect with your flight controller for power supply and recording.

Specification

Item: BEC Board for Naked Camera

Weight: 1.53g

Output: 5V @ 2A

Input voltage: 2-4S

Connector: GH 1.25 3P connector

BEC Board Diagram

The two buttons on the BEC board have the same functions as the GoPro spare buttons. Three actions we will use frequently.

Power on-Press the power/mode button, the LED flashes three times and goes out.

Start recording-Press the "Record" button once and the LED flashes slowly. If the LED flashes once and goes off, it means there is no SD card.

Stop recording-Press the "Record" button, the LED stops blinking slowly.

LED Status

Under normal operation, plug the GH1.25 connector into the GoPro Lite camera firstly, then connect with the battery. The LED will flash once, then you should press the Power/Mode button once in a second to power on. The LED on the BEC board has the same status as the stock LED on the GoPro mainboard.

Indication

Button Operation

LED Status

Power On

Press the Power/Mode button once

Flash 3 times and light off

Power Off

Press the Power/Mode button for 5 seconds

Flash 7 times and light off

Start Record

Press the record button once

Continuously slow flash